Aligning The Camera - Kompernass WK 8 B4 Mode D'emploi

Aligning the camera

In test mode, you can work out the optimum exposure angle and the
range of the motion sensors 5.
Align the camera as follows:
Fasten the camera to a tree or similar object at a height of 1–2 metres
and align the camera in the desired direction. Then move slowly from
one side of the target area to the other side. Note the information
provided by the LED display 2. If this flashes blue, you have been
detected by the motion sensor. In this way, you can work out the best
alignment for the camera.
The LED display only lights up when the mode selector switch z is
in the TEST position and the motion sensor has detected a motion.
During normal operation, there will be no LED display.
To ensure that the camera does not make unwanted recordings of
irrelevant movements, you should not set up the camera in a sunny lo-
cation or close to branches that move a lot in the wind. The detection
angle of the sensor is about 80° from corner to corner. The detection
range for photos is approx. 82° on the horizontal plane and approx.
56° on the vertical. The detection range for videos is approx. 80° on
the horizontal plane and approx. 40°on the vertical.
GB │ IE │ 37 ■
WK 8 B4