Electrical Connection - IFM Electronic efector duolis O2D200 Notice De Montage

Electrical connection

external
lighting
Note: Core colours of the process connection correspond to the socket E11231.
If the sensor is triggered internally the lilac wire of the external lighting must
be connected to minus.
Process connection M12, 8-pole
Pin Use
5 Output signal "READY" provides the status of the sensor:
"1" after the evaluation has been carried out.
"0" as long as the evaluation is being carried out, a different
parameter has been selected or in case of an internal error
(trigger signals are ignored).
6 Output signal "OUT" provides the result of the evaluation:
"0" contours do not match
"1" contours match
7,8 Inputs: External selection of the first four configuration files
(binary coded)
Pin 8 Pin 7
0
0
0 configuration file 1
1 configuration file 2
controller, e.g. plc
Pin 8 Pin 7
1
1
process connection
M12, 8-pole
1 - U+
2 - trigger input
3 - 0V
4 - trigger output
for external
lighting
5 - Ready
6 - OUT
7 - IN 0
8 - IN 1
0 configuration file 3
1 configuration file 4
9