Ooni Koda Manuel D'utilisation page 5

3. Connecting gas hose to Ooni Koda
Depending on your region the hose may be preassembled.
3a. Connecting gas hose directly to Ooni Koda
3b i). Connecting barb to Ooni Koda
3b ii). Connecting gas hose to barb
4
4. Connecting to gas tank
WARNING
• Please always keep the gas bottle in upright position.
• The size for 20 lbs LP gas cylinder is 12.2 inches in diameter and 17.9 inches tall
• If the appliance is not in use, the gas must be turned off at the supply cylinder.
• The cylinder used must include a collar to protect the cylinder valve.
• The minimum distance for the appliance and the 20lb gas tank is 40 inches apart.
PATIO GAS REGULATOR
This is a push-on gas fitting. Ensure that the black switch is in
the horizontal position. Depress the button located below the
black switch and press the regulator on to the tank valve until
it locks into place.
CONNECTING THE LIQUID PROPANE GAS CYLINDER
1. To connect the liquid propane gas cylinder:
2. The cylinder valve should be in OFF position.
3. Make sure the burner valve is in OFF position.
4. Inspect the valve connections, port and regulator assembly. Remove debris and inspect the hose for damage.
5. When connecting the regulator assembly to the valve, use your hand to tighten the nut clockwise until it stops.
Use of a wrench could damage the quick coupling nut and result in a hazardous situation.
6. Open the cylinder valve fully by turning the valve counterclockwise.
7. Before lighting the oven, use a soap and water solution to check all connections for leaks.
8. If a leak is found, turn the cylinder valve OFF, and do not use the oven until local liquid propane dealer can make repairs.
CONNECTING THE LIQUID PROPANE GAS CYLINDER
1. Turn the oven burner valve OFF and make sure the oven is cool.
2. Turn the liquid propane cylinder valve OFF by turning clockwise until it stops.
3. Detach the regulator assembly from the cylinder valve by turning the quick coupling nut counterclockwise.
4. Place dust cap for cylinder valve outlet whenever the cylinder is not in use.
POL GAS REGULATOR
This gas fitting is counterclockwise. Make sure that the tank
is completely switched off and screw the regulator as far as
possible into the gas tank valve.
5