dji TAKYON Z14120 Guide De Démarrage Rapide page 6

DO NOT use a direct-current power supply for testing to avoid
damage to the power supply when active braking function is
enabled.
Connection
Tools Required: Power distribution board (PDB)*, electric soldering iron
and soldering tin
1. Solder the ESC's black and gray power cables to the pads on the PDB.
2. Connect the signal cable to your flight controller. The signal cable's gray
wire transmits the control signal and the black wire is for ground.
Signal Cable
Data Cable
7
2
1
* Use a PDB which has sufficient trace spacing and current capacity, according
to the number of ESCs and the battery voltage.
Power Cables
3
6
4
5
ESC Cable Layout
1. GND
2. Control Signal
3. GND
4. S+
5. S-
6. Positive Power Cable (Gray)
7. Negtive Power Cable (Black)
© 2017 DJI All Rights Reserved.
Motor Cables
5