Dell UltraScan 1600HS Guide De L'utilisateur page 9

4 Using the ZOOM OSD
You can enlarge or reduce the picture size using the ZOOM
OSD.
This setting is stored in memory for the current input signal.
1 Press the MENU button to display the MENU OSD.
2 Highlight the ZOOM OSD using the BRIGHTNESS and
CONTRAST buttons and press the MENU button again.
3 Press the > (CONTRAST) ?// buttons to enlarge or
reduce the picture size.
4 Press the MENU button once to return to the MENU OSD,
or press it twice to return to normal viewing.
Note
You can enlarge or reduce the picture size until either the
horizontal or vertical size reaches its maximum or minimum
value.
Getting Started Customizing Your Monitor
5 Using the OPTION OSD
You can manually degauss (demagnetize) the CRT, select the
input signal, move the OSD position, set the Power Saving
delay time, and lock the user controls using the OPTION OSD.
1 Press the MENU button to display the MENU OSD.
2 Highlight the OPTION OSD using the BRIGHTNESS and
CONTRAST buttons and press the MENU button again.
3 Press the ¨ (BRIGHTNESS) ./> buttons to select the
desired adjustment item.
4 Press the > (CONTRAST) ?// buttons to activate the
manual degauss, select the input signal, move the OSD
position, change the Power Saving delay time or lock the
user controls.
5 Press the MENU button once to return to the MENU OSD,
or press it twice to return to normal viewing.
Degauss: If a second degauss cycle is needed, allow a minimum
interval of 20 minutes for the best result.
Input Signal Selection: Select the desired input signal when
two computers are connected.
OSD Position Change: To change the OSD position, press the
¨ (BRIGHTNESS) ./> buttons to select the direction
(horizontal or vertical), then press the > (CONTRAST)
?// buttons to move the OSD in the selected direction.
Power Saving Delay Time: The monitor enters Power Saving
mode after the selected time elapses. If you select "OFF," the
monitor does not go into Power Saving mode.
User Control Lock: Once you select "ON" to lock the user
controls, you cannot select any item except "EXIT" and
"OPTION" in the MENU OSD. If you try to access any other
OSD, the H mark appears on the screen.
To cancel the Control Lock: Repeat the above procedure and
set Control Lock to "OFF."
EN
F
ES
D
J
C s
C t
PL
9