Parts And Controls; Use Of The Tilt/Swivel; Getting Started - Dell UltraScan 1600HS Guide De L'utilisateur

Parts and Controls

Front
1
(RESET) button (pages 7 and 11)
Resets the adjustments to the factory settings.
2
(AUTO SIZING AND CENTERING) button
(page 6)
Automatically adjusts the size and centering of the
images.
3 ¨ (BRIGHTNESS) ./> buttons (page 6)
Adjust the picture brightness.
Operate as the ./> buttons when adjusting other
items.
4
(MENU) button (page 7)
Displays the MENU OSD.

Use of the Tilt/Swivel

With the tilt/swivel, you can adjust this monitor to any desired
angle within 180° horizontally and 20° vertically.
To turn the monitor vertically and horizontally, hold it at the
bottom with both hands as shown below.
15°
90°
5°
90°

Getting Started

Rear
5 > (CONTRAST) ?// buttons (page 6)
Adjust the contrast.
Operate as the ?// buttons when adjusting other items.
6 u (POWER) switch and indicator (page 12)
Turns the monitor on and off.
The indicator lights up green when the monitor is on,
and lights up orange when the monitor is in Power
Saving mode.
7 AC IN connector
Provides AC power to the monitor.
8 Video input 1 connector (HD15)
Inputs RGB video signals and SYNC signals
9 Video input 2 connector (5 BNC)
Inputs RGB video signals (0.7 Vp-p, positive) and SYNC
signals.
Video Input 1 Connector (HD15)
5 4 3 2 1
10 9
15 14
Pin No. Signal
1 Red
2 Green (Composite
Sync on Green)
3 Blue
4 ID (ground)
5 DDC Ground*
6 Red Ground
7 Green Ground
*
Display Data Channel (DDC) standard of VESA.
Getting Started
8 7 6
13 12 11
Pin No. Signal
8 Blue Ground
9 DDC +5V*
10 Ground
11 ID (ground)
12 SDA
(serial data)
13 Horizontal Sync
14 Vertical Sync
15 SCL
(serial clock)
EN
F
ES
D
J
C s
C t
PL
5