Read First; Damper Wire; Setup; Quick Specifications - Dell UltraScan 1600HS Guide De L'utilisateur

Read First!

Before making any monitor connections, review the
"Precautions" section on the next page.
If you have any problems with your Dell Monitor, refer to the
"Quick Specifications" section on this page and the
"Troubleshooting" section on page 13.

Damper Wire

When viewing a white background, two very thin horizontal
lines may be visible on the screen as shown below. These lines
are the damper wires.
The Trinitron tube has a vertically striped aperture grille inside.
The aperture grille allows more light to pass through to the
screen giving the Trinitron CRT more color and brightness.
These damper wires are attached to the aperture grille to
prevent vibration of the aperture grille and keep the screen
image constantly stable.
Damper wires
Problems?
NO PICTURE:
If the monitor fails to display an image, test the
monitor by using the SELF TEST function as described below.
Step 1 Turn off the monitor and disconnect the video cable
from the computer system.
Step 2 Turn on the monitor and wait five seconds.
The "NO INPUT SIGNAL" message should appear
with a color bar pattern. The message and pattern are
displayed for 60 seconds.
• If the monitor displays White, Red, Green and Blue, the
monitor is functioning properly.
"OUT OF SCAN RANGE" MESSAGE:
this message, reboot and refer to your computer system's
manual to change your display settings so they match the
monitor's capabilities (see the "Quick Specifications" section on
this page).
FLICKER:
To reduce flicker, refer to your computer system's
manual and change your display refresh rate settings so they
match the monitor's capabilities.
(See the "Quick Specifications" section on this page and the
"Troubleshooting" section on page 13 for additional tips.)
Approx. 9 cm
Approx. 9 cm
If the monitor displays
Getting Started

Setup

Connect the monitor to your computer system.
This monitor works with platforms running at horizontal
frequencies between 30 and 107 kHz.
Step 1 Make sure the computer system is switched off and
attach the video signal cable to the video output of the
computer.
To a computer
To a computer
Step 2 Make sure the monitor is switched off and attach the
power cord to the monitor. Then, attach the other end
of the power cord to a power outlet.
to a power outlet
to AC IN
Power cord
Step 3 Switch on the monitor and computer.
Step 4 Adjust the user controls according to your personal
preference.
Installation is complete.

Quick Specifications

Deflection Frequency Horizontal:
Vertical:
Approx. 403.8 × 302.2 mm (w/h)
Viewable Image Size
See the "Specifications" section on page 11 for more
information.
Maximum Resolution and Refresh Rates
Resolution Suggested
640 × 480
85 Hz
800 × 600
85 Hz
1024 × 768
85 Hz
1280 × 1024
85 Hz
1600 × 1200
85 Hz
Getting Started
30 to 107 kHz
48 to 160 Hz
(16 × 12 in.)
19.8 in. viewing image
Max.
160 Hz
160 Hz
130 Hz
100 Hz
85 Hz
3
EN
F
ES
D
J
C s
C t
PL