Speaker Balance Adjustment - Yamaha DSP-E492 Mode D'emploi

This procedure lets you adjust the sound output level balance between the main, center, and rear speakers using the built-in test
tone generator. When this adjustment is performed, the sound output level heard at the listening position will be the same from
each speaker. This is important for the best performance of the digital sound field processor and the Dolby Pro Logic Surround
decoder.
The adjustment of each speaker output level should be done at your listening position with the remote control transmitter.
Otherwise, the result may not be satisfactory.
Note
If this unit is connected with a Dolby Digital (AC-3) Decoder and/or an amplifier (or receiver) equipped with the Dolby Pro Logic
Decoder or the digital sound field processor, also make an output balance adjustment using the test tone on each unit.
2
NATURAL SOUND AV PROCESSOR/AMPLIFIER
POWER
EFFECT PRO LOGIC
1
40
Set to the "
2
Turn on the power of this unit and the external amplifier
etc.
3
Set the balance control, tone controls, etc. on the
external amplifier to the "flat" position.
4
TEST
18

SPEAKER BALANCE ADJUSTMENT

CINEMA DSP
DSP–E492
VCR
PRESET STEREO SLEEP NORMAL
ms dB
WIDE
kHz
PHANTOM
MHz 0 20 40 60 l00 EFFECT OFF
MEMORY AUTO PTY HOLD
TAPE MONITOR PRO LOGIC CONCERT MONO DISCO ROCK CONCERT
INFO AFFAIRS SPORT
ENHANCED VIDEO MOVIE STADIUM CONCERT HALL
PS PTY RT CT EON NEWS
TAPE (MD)
MONITOR
ENHANCED CONCERT VIDEO MONO MOVIE STADIUM DISCO ROCK CONCERT CONCERT HALL
CENTER
MODE
5
VOLUME
l6
20 l2
28 8
4
2
60
0
–dB
∞
" position.
POWER
1
VOLUME
l6
20 l2
TV/DBS DVD/LD
28 8
2CH/6CH 40 4
TUNER CD 60 2
(LINE 2) (LINE 1)
0
–dB
PROCESSOR
SELECTOR
INTERNAL
EXTERNAL
DELAY/
CENTER/REAR TIME/LEVEL
5
Select the center channel output mode suitable for your
speaker configuration.
(Refer to "SPEAKER CONFIGURATION" on page 7.)
On the feature of each mode, refer to the "Note" shown
below.
Note
In step 5, when you select a center channel output mode, note
the following.
For 5-speaker configuration)
NORMAL: Select this mode when you use a center speaker
WIDE:
For 4-speaker configuration)
PHANTOM: Select this mode when you do not use the center
TIME/
DELAY/CENTER
– +
LEVEL TEST
/REAR/SWFR
PROGRAM PROLOGIC ENHANCED
7
VCR TV/DBS
PLAY
DIR A DIR B REC/PAUSE
A/B
– + A/B/C/D/E TUNER L2
PRESET
PLAY
DISC
2CH/6CH VOLUME
6
CENTER
NORMAL
MODE
WIDE
PHANTOM
that is smaller than the main speakers. In this
mode, the bass tone will be output from the main
speakers.
Select this mode when you use the center speaker
approximately same sized as the main speakers.
speaker. The center sound will be output from the
left and right main speakers.
EFFECT
ON/OFF
4, 8
DVD/LD
TAPE
CD L1