Replacing Disposable Cartridge; Replacing Suction Nozzle; Scope Of Delivery - Weller DXV 80 Mode D'emploi

Dirt deposits in the taper area can be removed with the cleaning
insert (5 87 067 94) for the heating element taper.

4.2 Replacing disposable cartridge

Hold the desoldering iron with the suction nozzle upwards. To
replace the disposable cartridge, pull the filter receptacle (6)
towards the rear until it engages. The filter receptacle can now
be removed and the disposable cartridge (9) replaced. In so
doing, pay attention to the installation position with regard to
position (10) and throughflow direction (9) of the cartridge (see
(see figure).
Remove any remnants of solder from the inside of the desolde-
ring iron. Reinsert the filter receptacle together with the new
cartridge forwards into the handpiece (7) until flush and actua-
te the release (8). The desoldering iron is now ready for opera-
tion again (Drawing 2).

4.3 Replacing suction nozzle

Replace suction nozzles only when they are hot. Hold the dsol-
dering iron vertically. Attach the replacement tool to the suction
nozzle, release the suction nozzle with a short turning motion
(approx. 45°) and remove with the tool.
Caution
Risk of burns! The suction nozzle will still be hot after it is
removed.
Press gently against the heating element when inserting and
locating the new suction nozzle.

5. Scope of delivery

DXV 80 set
Unsoldering iron
WDH 40 holder
Cleaning brush
Taper cleaner
Cleaning tool
DX112 suction nozzle
DX113 suction nozzle
Operating Instructions
Disposable cartridges (5 pcs.)
Figure Suction nozzle range p. 47
Figure Exploded view p. 48
Subject to technical alterations and amendments!
See the updated operating instructions at
www.weller-tools.com.
DXV 80
Unsoldering iron
Cleaning brush
Taper cleaner
Operating Instructions
Disposable cartridges
(5 pcs.)
English
10