Troubleshooting - Zanussi ZRT23100WA Notice D'utilisation

To prevent water to collect in other parts of the
fridge, make sure that the drain hole is always
clean. Use the cleaning tool that is in the drain
hole.
Defrosting of the freezer
There can be frost on the freezer shelves
and around the top compartment.
Defrost the freezer when the layer of frost has a
thickness of 3 or 5 mm.
Caution! Do not use sharp metal tools to
remove the frost.
Do not use mechanical devices to defrost the
freezer.
1. Deactivate the appliance.
2. Remove all the food from the freezer. Wrap
the food in newspaper and keep it at a cold
temperature.
3. Keep the appliance door open until defrost-
ing is completed.
4. Clean and fully dry the freezer.
5. Connect the mains plug to the mains sock-
et.
6. Activate the appliance.
7. Set the temperature knob at the highest po-
sition and let the appliance operate for 2 or
3 hours with this setting.
8. Put back the food in the freezer.
When the appliance is not used for long
periods
1. Deactivate the appliance and disconnect the
mains plug from the mains socket.

Troubleshooting

Warning! Disconnect the mains plug from
the mains socket before you do the check.
Problem
The appliance makes noise during
operation.
The appliance does not operate.
www.zanussi.com
2. Remove all the food.
3. Defrost the appliance.
4. Fully clean and dry the appliance and all the
accessories.
5. Keep the doors open to prevent unpleasant
smells.
Replacing the lamp
1. Disconnect the mains plug from the mains
socket.
2. Remove the screw from the lamp cover.
3. Remove the lamp cover
4. Replace the old lamp with a new one. Use
only lamps for household appliances. The
lamp cover shows the maximum power of
the lamp.
5. Install again the lamp cover.
6. Connect the mains plug to the mains sock-
et.
The type of light bulb or halogen lamp used
for this appliance, is only for household ap-
pliances. Do not use it for house lightning.
For problems that are not in the table, contact
the Service.
Some sounds are normal when the appliance is operating. Refer to the
leaflet supplied with the appliance.
Make sure that the appliance is activated.
Make sure that the mains plug is connected to the mains socket.
Possible solution
15