Possible Faults; Technical Data - ATIKA KSH 710 SDS Notice Originale

Before each fault elimination:
− switch off device
− Wait for the power pruner to come to a standstill
− Pull out power plug

After each fault clearance, put into operation and recheck all security installations.
Fault
Power pruner does not
start after switching on
Power pruner works
with interruptions
Power pruner picks,
vibrates or does not
saw correctly
Power pruner does not
work with full power
Saw chain gets hot
No saw chain
lubrication
Typ / Model
Year of construction
Motor rating P
1
Mains voltage
Mains frequency
Mains fuse
No-load speed of the sprocket
Saw chain speed
Oil tank volume max.
Protection class
Saw chain
Guide bar
Cutting length
Measured sound power level L
Guaranteed sound power level L
Measuring uncertainty K
WA
Sound pressure level L
PA
Measuring uncertainty K
PA
Hand arm vibration a
vhw
Measuring uncertainty K
Weight without cutting assembly and with empty oil tank
24
Possible cause
 no power
 Extension cable damaged
 Mains plug, motor or switch defect
 external loose connection
 internal loose connection
 ON / OFF switch defective.
 Chain edgeless
 Chain worn
 Chain tension
 Chain not assembled correctly (teeth
face to wrong direction)
 Extension cable too long, or cross-
section too small.
 Socket too far from mains supply.
 no oil in the tank
 oil flow canal blocked
 chain tension too high
 Chain edgeless
 no oil in the tank
 oil flow canal blocked
WA
WA

Possible faults

Remedy
 Check power supply, power outlet, fuse protection
 Check extension cable,
immediately
 Have motor or switch checked by an approved electrician
or replaced by original spare parts
 Contact the customer service
 Chain must be regrinded or exchanged
 Exchange chain
 Check and adjust chain tension
 Assemble chain again
 Only use extension cables with sufficient core cross-
section.
 Use power outlet which is nearer within the working area
 Refill oil
 Clean oil flow canal
 Adjust chain tension
 Chain must be regrinded or exchanged
 Refill oil
 Clean oil flow canal

Technical data

KSH 710 SDS
see last page
710 W
230 V
50 Hz
10 A inert
8300 min
-1
13 m/s
150 ml
ΙΙ /
90JG033X, alternative 90PX033X (3/8 " – 1.1 – 33)
084LNE A041  203 mm (8'')
180 mm
101.9 dB (A) (measured according to regulation 2000/14/EC)
103 dB (A) (measured according to regulation 2000/14/EC)
0.31 dB (A)
83 dB (A) (accordingto regulation 2000/14/EC)
3.0 dB (A)
3.64 m/s
2
1.5 m/s²
approx. 4.5 kg
exchange defect cable