Yakima SideWinder Manuel D'installation page 4

Attach SideWinder to the crossbars.
Do you have square or
round crossbars?
IF BARS ARE ROUND, CONTINUE BELOW.
Attach two brackets per
crossbar, with bracket opening
toward the center of the vehicle.
Position the sideWinder
outboard as far as possible
on the crossbars.
Attach the four hex keys and tighten.
1032613E-4/24
if you have square
bars, loosen the
tabs in the brackets
by bending them
repeatedly.
REAR CROSSBAR:
insert two bolts into the
rear plate (near the tray).
Remove the tabs with
scissors or pliers.
FRONT CROSSBAR:
install the U-bolt over the bar and
into the plate and brackets.
• PAD on the plate must be
installed upward.
• holEs must be toward the
rear crossbar.
Lock quick release lever.
if you have purchased a lock, follow lock
core instructions to install the lock.