Inserting The Battery In The Remote Control; Using The Antennas - Sonoro RELAX SO-810 Mode D'emploi

Masquer les pouces Voir aussi pour RELAX SO-810:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 123
3.3

Inserting the battery in the remote control

1. Open the battery compartment cover on the back of the remote
control by turning it anticlockwise using a small coin.
2. Insert the supplied batteries (CR2032, 3 V) with the label (+) side up.
3. Replace and close the battery compartment cover by turning the
cover clockwise using a small coin.
i
Do not block the infra-red sensor on RELAX and the infra-red
transmitter on the remote control during use.
3.4

Using the antennas

1. The scope of supply contains a cable antenna and a rod antenna. For
optimum radio reception, one of the two antennae must be used.
2. Screw the desired antenna located on the back of RELAX to the
FM/DAB antenna connector.
80
© sonoro audio GmbH 2017

Publicité

Table des Matières
loading

Table des Matières