M-Audio air 192 Mode D'emploi page 4

To set AIR 192|8 as your default playback device, follow the directions below based on your
computer's operating system.
Windows:
1. Use the included USB cable to connect the AIR 192|8 to your computer.
2. In the Taskbar, locate the Volume Control "speaker" icon. Right-click the speaker and open
Sound Settings > Sounds.
Alternatively, go to Start Menu > System > Sound > Sound Control Panel.
3. In the Windows Sound control panel select the Playback tab and select AIR 192|8 as the
default device.
4. Click the Recording tab and select AIR 192|8 as the default device.
5. Click Properties in the lower right-hand corner.
6. In the new window, click the Advanced tab and select 2-channel, 24-bit, 48000 Hz (Studio
Quality) as the default format.
7. Uncheck both boxes under Exclusive Mode.
8. Click OK to close the Properties window.
9. Click OK to close the Sound control panel.
macOS:
1. Use the included USB cable to connect the AIR 192|8 to your computer.
2. Go to Applications > Utilities > Audio MIDI Setup.
3. In the Audio Devices window, select AIR 192|8 in the left column.
4. Right-click AIR 192|8, and select Use this device for sound input.
5. Right-click AIR 192|8, and select Use this device for sound output.
6. Quit Audio MIDI Setup.
Setting Up AIR 192|8 with Pro Tools | First M-Audio Edition
1. Use the included USB cable to connect the AIR 192|8 to your computer.
2. Open Pro Tools | First M-Audio Edition.
3. Go to Setup > Playback Engine....
4. Open the Playback Engine dropdown menu and select M-Audio AIR 192|8.
Note: You may need to save and restart your project.
5. Select your Sample Rate and then click OK to close the Setup window.
6. Go to the Setup > I/O and select M-Audio AIR 192|8 for the Input and Output devices.
You can now add tracks to send and receive audio and MIDI from sources connected to AIR 192|8
inputs and stream recorded audio back through the AIR 192|8 outputs.
Setting Up AIR 192|8 with Ableton Live Lite
1. Use the included USB cable to connect the AIR 192|8 to your computer.
2. Open Ableton Live Lite.
3. Go to Preferences > Audio tab.
4. Click on Driver Type to select CoreAudio (Mac) or ASIO (Windows).
5. Select AIR 192|8 in the Input and Output Config section.
6. Select your Sample Rate and then close the audio preferences window.
You can now add tracks to send and receive audio and MIDI from sources connected to AIR 192|8
inputs and stream recorded audio back through the AIR 192|8 outputs.
4