Getting Started - Corsair ST100 Mode D'emploi

GETTING STARTED

Connect the included USB 3.1 cable to the USB to PC Micro-B port on
the back of the ST100 RGB headset stand. Connect the opposite end
to a USB port on your PC. After connecting to your PC, we recommend
installing the CORSAIR Utility Engine (CUE) to ensure you have the
latest firmware and drivers.
USB 3.1 PORTS
Two high speed USB 3.1 (Gen 1) ports are included. These ports are
backwards-compatible with all USB 2.0 devices.
Note: In order to realize USB 3.1 performance, the USB port on your PC must also support
USB 3 or higher specifications. Otherwise, performance is limited to the USB specifications
of your PC.
3.5MM HEADSET JACK
A 3.5mm headset jack provides compatibility with any headset or
headphone that has a 3.5mm analog connector. 7.1 virtual surround
sound can be enabled using the CORSAIR Utility Engine (CUE).
RGB LIGHTING CONTROL
A total of 9 fully customizable RGB LED zones are available using the
CORSAIR Utility Engine (CUE).
CORSAIR UTILITY ENGINE
• Go to corsair.com/support/downloads to download
the CORSAIR Utility Engine ('CUE') Software.
Using the CUE software will enable the full feature set of the ST100 RGB
headset stand.
Note: if the stand is used without software, some features will be disabled.
• Install the software on a PC running Windows 10, Windows 8, or Windows 7.
• After installation is complete, reboot your PC, and launch CUE.
You can use it to:
• Choose your RGB color preference and light intensity
• Select and customize audio equalizer (EQ) settings
• Set 7.1 surround sound on or off
The software's built-in documentation explains how to use the ST100 RGB
headset stand's features in greater detail.
4