Fimap FA 30 Manuel D'utilisation page 13

Avvertimenti, Warnings, Waarschuwingen, Advertencias
GB
CLEANING AND MAINTENANCE OF THE VACUUM CLEANER
Disconnect the plug from the source of electricity (figure 26), unhook the tank latches (figure 27) and remove
the head and the dust filter from the tank (figure 28). Bend the vacuum cleaner until the handle touches the
floor and empty the contents of the tank into another container (figure 29). Then put the tank back into its
original position (figure 30) and if necessary (for dry vacuum cleaning only) insert the dust filter (figure 3),
place the head in its correct position and secure it onto the tank with the latches (figure 31) and start cleaning
again.
ATTENTION!
Before performing any cleaning and maintenance on the vacuum cleaner, always disconnect
the plug from the source of electricity. Make sure that the cable is not cut or damaged (if it is, apply to the
nearest authorized service centre for replacement).
a) Clean the tank, do not let it stand for a long time with dust or dirty water.
b) Clean the cloth filter frequently.
c) Always use only original replacement parts and attachments.
TROUBLE-SHOOTING
The motor is built for maintenance free operation and does not need any particular service. The carbon
brushes may need to be replaced due to normal wear and tear caused by using the vacuum cleaner over
time, and they can be replaced only by our authorized service centers.
1) PROBLEM: The machine does not work. CHECK the following points:
a) Check if the plug is connected to the source of electricity.
b) Check if the switch is in the on position.
c) The tank may be filled with liquid. lf it is, empty the tank, following the instructions given in this
booklet.
2) PROBLEM: The machine does not have enough suction. CHECK the following points:
a) The filters may be dirty. lf they are, clean or replace them, following the instructions given in this
booklet.
b) The suction hose may be obstructed. lf it is, turn off the vacuum cleaner, and then remove the
cause of obstruction.
c) The tank entry may be obstructed. lf it is, turn off the vacuum cleaner, and then remove the
cause of obstruction.
ATTENTION!
Before performing any cleaning and maintenance on the vacuum cleaner, always disconnect
the plug from the source of electricity. Make sure that the cable is not cut or damaged (if it is, apply to the
nearest authorized service centre for replacement).
Warnhinweise, Reccommandations importantes,
pag. 13