Fimap FA 30 Manuel D'utilisation page 12

Avvertimenti, Warnings, Waarschuwingen, Advertencias
GB
ATTENTION
Read all the instructions and warnings in this user manual carefully and keep the booklet for future
reference. Failure to carry out all these instructions can result in potential hazards from the machine. The
packaging components (plastic bags, staples, etc..) are potentially dangerous and should be kept out of the
reach of children and handicapped persons. After having opened the packaging, examine the contents to
make sure that it is intact and, in case of missing or defective parts, contact an authorized dealer or service
centre before using the machine, in order to receive the original parts. Before connecting the machine to the
source of electricity, make sure that the electrical specifications mentioned on the technical label on the
machine, are the same as the source of electricity. This machine is designed to be used only as intended:
vacuum cleaning of immobile surfaces, and the vacuuming of solids and liquids which are not inflammable or
explosive. All other uses are to be considered as improper and potentially dangerous. Avoid bringing the
attachment in use, into close proximity of sensitive organs such as eyes, ears, etc.. Do not leave the machine
within reach of unattended children or handicapped persons. Do not leave the machine connected to
electricity when not in use. Before cleaning or carrying out any maintenance work on the machine,
disconnect it from the source of electricity. Never immerse the machine in water, and never use the machine
to vacuum harsh solvents and liquids and foam producing chemicals. Do not bring harsh solvents and liquids
into contact with the machine. The manufacturer cannot be held responsible for any damage to persons,
animals, or objects as a result of incorrect and/or improper use of the machine and due to the user's failure to
carry out all the above instructions and warnings.
TO USE AS DRY VACUUM CLEANER (not to vacuum liquids)
Make sure that the plug is disconnected from the source of electricity (figure 1). Unhook the tank latches
(figure 2), remove the head and ensure that the cloth filter is properly installed (figure 3). Put the head in its
original position again and secure it onto the tank with the latches (figure 4). lnsert the flexible hose in the
tank entry (figure 5) and assemble the two steel wands onto the flexible hose (figure 6). Connect the plug to
the source of electricity (figure 7), push the switch to the on position (figure 8) and start cleaning. For the
cleaning of floors or parquets, assemble the special floor brush tool (figure 9), and for use on carpets and
broadloom, assemble the carpet tool (supplied on request) as in (figure 10). For the cleaning of hard-to-reach
areas, such as the inside of cars, etc.., you must use the crevice tool, assembled as in (figure 11) and used
as in (figure 12,13). The special dust brush for cleaning furniture, and carpets and upholstery inside cars, and
useful for the cleaning of small surfaces and angles is also included and must be assembled as in (figure 14)
and used as in (figure 15). At the end of the work turn off the machine by pushing the switch to the off position
(figure 16), disconnect the plug from the source of electricity (figure 1) and clean the tank following the
instructions in this booklet.
TO USE AS WET VACUUM CLEANER (to vacuum liquids)
Make sure that the tank does not contain dust. Disconnect the plug from the source of electricity (figure 17),
remove the head (figure 18), remove the dust filter (figure 19). Put the head in its original position and secure
it onto the tank with the latches (figure 20), connect the plug to the source of electricity (figure 21), turn on the
machine by pushing the switch to the on position (figure 22) and start cleaning, using the special tool (figure
23) or the squeegee tool (figure 24). At the end of the work, turn off the machine by pushing the switch to the
off position (figure 25), disconnect the plug from the source of electricity (figure 17) and remove the liquid
from the tank following the instructions in this booklet.
ATTENTION!
The vacuum cleaner is furnished with a system which interrupts the suction when the tank has
reached its maximum capacity. When this occurs,empty the tank, following the instructions in this booklet.
ATTENTION!
for particular thick liquids suction (chemical water with shavings, mud, leaves) use the special
nylon filter (optional).
pag. 12
Warnhinweise, Reccommandations importantes,