Franke F PRO ENERGY EU16 Mode D'emploi page 6

G B G B
When the crossed-out wheelie bin symbol is attached to a product, it means that the product is covered by European
Directive 2002/96/EC.
Your product is designed and manufactured using high-quality materials and components which can be recycled and used
again.
Please take time to enquire about your local electrical and electronic waste sorting system.
•
Please respect local regulations and do not dispose of your used products with everyday household waste.
•
If you dispose of your used product in the correct way, you will help to prevent any potential adverse
•
effects against the environment and human health.
This appliance should not be used by anyone (including children) with reduced psychic, sensory or mental capacities or
by anyone who does not have experience and knowledge of this type of appliance, unless they are under the control and
guidance of those responsible for their safety. Special care should be taken to make sure that children do not play with
The fitting and connection must be done by a qualified installer*.
•
• Use appropriate plugs for the support. Ask the manufacturers and seal if necessary. The Company disclaims any res-
ponsibility in case of faulty mounting due to the drilling and the plug.
• The separate motor (3) must be installed indoors (attics, adjoining rooms).
• Respect the output diameter of the device.
GB
• Do not reduce the sections of the drain pipes (1) (4).
• Avoid the formation of bends in the installations of drain pipes. Optimize the lengths.
Guide the air flows.
•
The length of the drain pipe located between the separate motor and the outside drain output must be over or equal
•
to the length of the drain pipe located between the hood (sensor) and the separate motor input.
• To secure the hoses and/or pipes on the inputs and outputs of devices, use clamp collars or
• aluminium coated adhesive tape.
The maximum vacuum created in the room must be less than 0.04mbar, which prevents a return of combustion gas.
•
The device must be positioned in such a way as the power plug is accessible.
•
• If the separate motor and drain pipes are installed in a particularly cold room, use thermal insulation.
It is preferable that the output of the separate motor is directed upwards forming a vertical axis with the separate motor
•
input.
• It is preferable that the separate motor should be installed at a higher height than that of the hood.
• Place the anti-return check valve (2) at the separate motor output and before the drain pipe that leads to the outside
output.
THIS EQUIPMENT COMPLIES WITH THE FOLLOWING REGULATIONS:
2006/95/EC on electrical safety, 2004/108/EC on electromagnetic compat-
ibility, 93/98 on marking, 65/2014 on energy labelling 2010/30/EU 66/2014
on ecodesign 2009/125/EC, IEC 60704-2-13, IEC 60335-2-31 Article 7 IEC
60335-1 Article 7-1
ASSEMBLY RECOMMENDATION
*any failure to meet this condition invalidates the manufacturer's warranty and any action in the event of an accident.
the appliance.