Install Infant Car Seat - Quinny ZAPP XTRA Guide D'utilisation

WARNING
To avoid serious injury:
• Use ONLY Maxi-Cosi Mico
included) with this stroller.
• Please refer to the manufacturer's instructions for
the use of your infant car seat.
• ALWAYS install car seat facing to the rear of the
stroller.
• ALWAYS use the restraint system in the car seat.
15
Install Infant Car Seat
Remove the seat and seat adapters (see steps 9 and 10). Push the
parking brake pedal down.
Insert left and right car seat adapters into frame hub until you hear a
"click" as shown (Figure 15).
Car seat must face handlebar.
adapters until both sides "click" (Figure 15a). Lift up on handle to
ensure it is securely in place.
To remove car seat, press both buttons on car seat (Figure 15b). Lift
car seat up.
To remove car seat adapters, press grey button and slide adapter off
hinge points (Figure 15c).
TM
infant car seat (not
®
Lower car seat into car seat
15
15a
15c
7
To Use
15b