Carpet Cleaner - Cleanfix SC1250 Foam Mode D'emploi

Carpet cleaner

Assembly and use when used as a carpet cleaner
1. Fill the fresh water tank (1) with hot water (max. 50° C) and, when cleaning carpets, with cleaning agent
up to approx. 5 cm below the edge. (Note the detergent dosage according to the manufacturer).
A tank filled beyond this point leads to overflow of the dirty water tank. The liquid may be dangerous
due to its temperature, pressure or chemical composition.
In case of foam or liquid leakage, switch off the unit immediately!
6. Before using the device, always check the "colour fastness" of the carpet first. Apply a small amount of
detergent to a white cloth and rub briefly onto the carpet in a concealed place.
If the carpet is not "colourfast", the white cloth discolours.
7. Spray suction procedure
a. Set the switch "suction motor" (7), then set the switch „pump" (8) to ON.
8 7
b. When the lever valve (X) is actuated, the cleaning fluid is sprayed into the carpet
c. While operating the lever valve (X), pull the suction nozzle evenly over the carpet.
d. For thorough cleaning, pull the suction nozzle (Z) slowly. To shorten the drying
e. If no more cleaning liquid sprays out of the spray nozzle, switch off the unit; empty
8. After cleaning the carpet, switch off both switches, empty the device and fill the fresh water tank with
approx. 2 litres of clean water. Switch on the suction motor and pump switches and pull the lever valve.
Spray the rinsing solution into a container. This will clean the hoses and pump and ensure that your
machine functions properly. Then clean the device thoroughly with a damp cloth.
9. Before removing the spray hose, release the pressure by briefly pressing the lever valve. Push back the
plastic ring of the coupling and remove the spray hose.
10. To shorten the drying time of your carpets, ventilate rooms well.
2. Connect the suction hose (A) to the suction hose connection (5).
Press the connection nipple for the device into the connection coupling (4).
3. Fill the dirty water tank with defoamer (Cleanfix special accessory, observe
dosage according to manufacturer). This prevents strong foam formation.
4. Check the seat of the dirty water tank cover (3).
5. Insert the end of the suction hose (C) firmly into the hand tube of the carpet
adapter (17/18); insert the coupling (D) of the spray hose firmly into the nipple on
the lever valve (E).
floor. The dirt stuck in the carpet is loosened and flushed to the surface. The dirt is
sucked off via the suction nozzle (Z).
At the end of a track, release the lever valve (X) and lift the suction nozzle off the
carpet. Then start with a new lane, which overlaps the already cleaned lane by
approx. 2-3 cm.
time, vacuum the carpet again without activating the lever valve (X).
dirty water via the drain hose (11), top up the water and cleaning agent in the fresh
water tank and continue working.
| 19 | 19 | 19