Stihl FS 410 C-M Notice D'emploi page 19

NOTICE
The thrust plate (1) is required for
mounting all cutting attachments to the
gearbox.
NOTICE
The guard washer (4) is required for
mounting brush knives.
Cleaning Gearbox Mounting Hardware
for Cutting Attachment
NOTICE
Check inside of guard ring (3) and area
around it for dirt at regular intervals, or
when you change the cutting
attachment, and clean if necessary.
The guard washer (4) is not fitted with
circular saw blades.
Pull the guard washer (4) and thrust
N
plate (1) off the shaft.
Thoroughly clean the guard ring (3),
N
shaft (2), thrust plate (1) and guard
washer (4) – do not remove the
guard ring.
Mounting the Guard Ring
Always fit the guard ring that matches
the cutting attachment you intend to use.
Recommendation: The guard ring must
be mounted with particular care. Have
this work performed by your servicing
dealer. STIHL recommends a STIHL
servicing dealer.
FS 410 C-M, FS 460 C-M
The following guard rings are either
fitted to the gearbox or are available as
special accessories.
Guard ring for mowing applications
A limit stop kit, which includes a
deflector, a guard washer and guard ring
for mowing attachments, is available as
a special accessory for mounting brush
knives.
3
2
1
For optimum protection from the ingress
of grass when using mowing
attachments:
Mount the guard ring (1) for mowing
N
applications.
Fit the thrust plate (2) and the guard
N
washer (3).
Guard ring for sawing applications
2
1
For circular saw blades
Fit the guard ring (1) for sawing
N
applications.
Fit the thrust plate (2).
N
Blocking the Shaft
1
3
2
The output shaft (1) must be blocked
with the stop pin (2) to mount or remove
cutting attachments. The stop pin is
included with the machine and is
available as a special accessory.
English
2
17