Intended Use; Water Pressure - Judo EASY FILT-B JEF-B Instructions De Montage Et De Service

2.

Intended use

The installation and operation of the filter is
subject to the following country-specific
regulations.
In addition to the operating instructions and
the obliging regulations concerning accident
prevention that exist in the country of opera-
tion and the location of use, the established
technical regulations concerning safe and
professional work, should also be observed.
The water to be filtered must have
drinking water quality!
It is absolutely essential that the manufac-
turer / supplier will be consulted prior to any
operation of the device using water of a
different quality, respectively with water that
contains additives.
This filter is suitable for use in cold drinking
water up to a maximum ambient tempera-
ture of 30 °C (86 °F).
The filter has been developed and manufac-
tured using state of the art technology and
the established
Germany.
The filter may only be operated in accor-
dance with the manufacturer's specifica-
tions. Any other operation or operation
beyond the specified use, is not in accor-
dance with the manufacturer's specifications.
Additional dangers may result in the event of
the device not being operated in accordance
with the manufacturer's specifications and
non-observance of the danger symbols or
safety instructions. The manufacturer /
supplier cannot be made liable for any
damages caused
dangers. The operator is responsible for
these risks.
The use of the device in accordance with the
customer's specifications
observance of the operating instructions.
safety regulations
by these additional
includes
JUDO EASY FILT- B
Intended use
The manufacturer/supplier
consulted prior to any operation of the filter
other than in the operational areas stated in
these operating instructions.
The filter may only be operated in a techni-
cally faultless condition, in accordance with
the manufacturer's specifications and the
stated safety and danger relevant instruc-
tions and under observance of the operating
instructions!
Any functional defects are to be removed
immediately!
2.1

Water pressure

The water pressure should be between 1.5
bar and 10 bar.
The water pressure must not exceed 1.5 bar
as otherwise the backwashing can be
impaired! If the filter is not backwashed
regularly a pressure loss can result and this
can impair the filter function.
ATTENTION
in
(see chapter
dangers due to non-compliance")
In the event of water pressure above 10
bar, the pressure reduction valve should be
fitted in front of the filter (see fig. 2). If the
operating pressure is above 10 bar, this may
result in defects during operation.
1 = Pressure reducer
the
Fig. 2: Pressure reducer upstream of the unit
should
"Safety information
1
be
and
5