Burda BRELG1200 Mode D'emploi page 23

Connection to electric mains
• The heater is designed for connection to the single-phase 230-240V~ 50Hz electric mains equipped with a earth.
• Before connection, make sure that specifications of the electric mains at the connection point meet the single-phase
230-240V~ 50Hz voltage.
• The electric mains should be equipped with an automatic circuit breaker with rated current not less than 16A.
• The heater must not be located immediately below a power point. Power point should not be located at the back of
the heater. The power point needs to be located outside the physical footprint of the heater to minimize heat build-up
behind the heater.
• If the heater is to be mounted on an incline (eg. Vaulted ceiling), ensure the power point located at that lowest point
of the heater.
MAINTENANCE
• Any maintenance should only be carried out by a qualified electrician.
• During operation, it is necessary to periodically (once a year) check the electric cable contacts and terminal connectors
for good tightening.
• If the body becomes dirty, wipe off dust with a towel, and the radiating boards should be wiped in cold condition with
a damp soft rag.
WARNING! Never immerse the appliance in water! Danger to life!
23