Intended Use; What's In The Box; Safety Instructions - Burda BRELG1200 Mode D'emploi

IMPORTANT INFORMATION
Please carefully read the Operation Manual before using
the infrared heater. This Operation Manual contains the
important information on your safety, as well as some
recommendations on proper use of the appliance and its
maintenance.

INTENDED USE:

The device is warming outdoors.

WHAT'S IN THE BOX

 Heater fitted with flexible cord and plug.
 Operating and Installation Instructions.
 One small box contains 2 sets of Brackets.
 One remote controller , only for remote control model

SAFETY INSTRUCTIONS

 During use of the infrared heater, it is necessary to
observe some precautions. Improper operation with
disregard of precautions may result in infliction of
harm to health of the user and other people, as well as
in infliction of damage to their property.
 Use only the voltage specified on the rating plate of
the heater.
 ONLY connect the appliance to a properly installed
socket-outlet with earth contact.
 The heater should be connected to the electric mains
equipped with an automatic circuit breaker.
 The unit must be handled with care, and avoid
vibration or hitting.
 WARNING: FIRE RISK EXISTS IF THE HEATER IS
COVERED BY OR POSITIONED CLOSE TO CURTAINS OR
OTHER COMBUSTIBLE MATERIALS. Do not place any
clothing, towels or similar to dry over the heater!
Overheating and risk of fire!
 Do not use the appliance areas where gasoline, paint
or other flammable liquids are used or stored.
 Do not use the appliance in particularly in dusty or
where explosives are stored.
 Do not use the appliance in a building site, green
house, barn or in animal stables.
 Do not use the appliance as a sauna heater.
 Do not use this unit in the place of animal propagating
and rising.
 Warning:
Do not
Temperature of radiating boards during operation of
touch the radiating
the heater may reach 380 °C. To avoid burns, do not
touch the appliance surface by hand and other body
parts. It is also necessary to avoid touching the heater
whilst the appliance is switched on, as severe burns
may result. The appliance can take up to 1 hour to cool
down after switching it off.
 Do not place any items of clothing, hand towels or
similar over the heater to dry. Risk of overheating and
fire hazard.
 Do not leave the heater unattended whilst in use.
 Do not use this heater on a wet surface, or where it
can fall or be pushed into water.
 Do not reach for an appliance that has fallen into water.
Switch off at supply and unplug immediately.
 If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
 If the heater is defective, it must be checked and
repaired by the manufacturer, its service agent or
similarly qualified persons for repair.
 Do not operate appliance with wet hands.
 Use this appliance only as described in this manual.
Any other use is not recommended by the
manufacturer and may cause fire, electric shock or
injury.
 Do not use abrasive cleaning products on this
appliance. If the body becomes dirty, wipe off dust
with a cloth, and the radiating boards should be wiped
in cold condition with a damp soft cloth. Always
remove plug from the mains supply before cleaning.
 The heater must be installed at least 1.8 m above the
floor.
 The heater must not be located immediately below a
socket-outlet. The heater must not be located in front
of a socket-outlet. They should be located outside the
physical footprint of the units to minimize heat
build-up behind the heater.
 The installation must be equipped with a standard
electrical power point with a break contact distance of
at least 3mm. The standard power point must be
installed by a licensed electrician.
 If the heater is to be mounted on an incline (eg.
Sloping or angled ceiling), ensure the electrical
connection is located at that lowest point of the
plate.
heater.
 Do not connect the appliance to the mains source until
14