Burda BRELG1200 Mode D'emploi page 17

NOTE:

After switching on the appliance for the first time and following extended periods on non-use, the appliance may expel a slight odor
for a short time. It will not affect the use of the heater.

To exclude unpleasant burnt odor, it is recommended to keep the heater clean preventing accumulation of dust on it.

The distance between the heater and the remote control should be less than 3 metre
and the remote control must be directly point to the receiver on the front panel during the operation.
BRELG1200
Warming: In case of direct connection to the supply line, a bipolar switch or a bipolar circuit breaker with contact
opening distance of at least 3mm must be fitted upstream from the supply line. Contact an authorized service
technician if you are unsure if you have a switch or a circuit breaker installed on the premises.

Plug in the device in the socket of main power, the heater starts heating.

Unplug the device from the socket or press the switch or the circuit break to power off the device.
BRELG1200R
Power on the unit
1. Plug in the device, the device will sound 1 beep, the device is in standby mode, the heating status lamp is flashing
(Picture 1).
(picture 1)
2. Press the button "ON" on the remote control, the device starts to heat, and the heating status lamp will turn in red
(picture 2)
(picture 2)
3. Press the button "standby" on the remote control, the device will sound 1 beep and revert to Standby Mode, the
Stand-by lamp is flashing (picture 1).
4. Power off the unit, unplug the device from the socket or press the switch or the circuit break to power off the device.
Set the Timer function
Press the Timer control buttons "1hr", to activate 1-hour delay-off timer function. The heating status lamp will turn to
green (picture 3), the device will be switch off after 1 hour, and revert to standby mode (Picture 2).
(picture 3)
BRELG1500, BRELG1800, BRELG2200, BRELG3000
Connect the unit to the main power, press the switch to the position of I : ON, the red operation indicator will light to
indicate the heater is on and the heater will begin to radiate infrared heat.
Heating status lamp
17