Hendi 215005 Mode D'emploi page 5

Parts
Part No. Parts
1 Lid
2 Frying basket
3 Grid
4 Control panel
5 Faucet
6 Ventilation outlet
7 Screws (for fixing part [6])
8 Filter
9 Temperature sensor
10 Body
Preparations before using for the first time
• Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable).
• Clean the appliance with luke-warm water and a
soft cloth.
Installation
1. Make sure that the ventilation outlet [6] and the
screws [7] are properly installed and that the ven-
tilation outlets have not been blocked.
2. Make sure the filter [8] has been installed and has
not been obstructed.
3. Make sure the faucet [5] has been closed.
Control Panel
• Place the appliance on a level and steady surface,
unless mentioned otherwise.
• Make sure there is enough clearance around the
appliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible at all times.
4. Pour oil into the oil tank slowly, make sure that
the oil level is higher than the "MIN" mark and not
higher than the "MAX" mark.
5. Make sure that the electric plug has been con-
nected.
EN
5