Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Intended Use
• Ensure that all electrical power to the toilet is turned
off, and for marine applications, ensure that seacocks
are in the closed or off position before installing the
toilet or performing any maintenance.
• For marine applications, if the toilet is connected to
any through-the-hull fittings, all flexible hoses must
be of marine sanitation quality and must be secured
to any fittings (such as those at the seacock, vented
loop, or toilet) with two stainless steel, worm-drive,
hose-band clamps at each connection. Check the
connections frequently for integrity.
• For marine applications, use properly positioned,
ventilated loops when the potential exists for the
toilet rim to fall below the waterline during any
heel, load, or trim condition, or when the toilet
is connected to any through-the-hull fittings. The
ventilated loops must be installed in the intake (if
connected to raw water) and/or the discharge
piping.
• For marine applications, if the toilet uses raw water
for flushing at any time, a raw-water pump controlled
by an automatically operat ing demand switch must
not be installed. If the onboard water valve or any
plumbing connections were to leak, the automatically
operated pump would start and could flood the boat
or RV.
2 Intended Use
The 4300, 4400, and 6500 series toilets are designed
and intended for use only inside the boat or recreational
vehicle (hereinafter referred to as "RV") for which it
is supplied. Use these instructions to ensure correct
installation of the toilet. Dometic Corporation accepts no
liability for damage in the following cases:
• Faulty assembly or connection
• Damage to the product resulting from mechanical
influences and excess voltage
• Alterations to the product without expressed
permission from Dometic Corporation
• Use for purposes other than those described in the
operating manual
Dometic Corporation reserves the right to modify
appearances and specifications without notice.
4
Full Ceramic Gravity Discharge Toilet
3 General Information
This section provides reference information on the
tooling, wiring, and specifications associated with the
toilet series.
I
The images used in this document are for reference
purposes only. Components and component
locations may vary according to specific product
models. Measurements may vary ±0.38 in. (10 mm).
Included Parts
Toilet
Discharge adapter fittings
Floor mounting hardware kit
Floor-mounting template
Optional Parts
1
DTM01C tank monitor
DTM04 four-level tank monitor
Available as an accessory (not included)
1
3 .1 Materials
This section outlines the toilet component materials.
Component
Toilet
Dometic switch (4400 only)
Touch panel (6500 only)
Flush handle (4300 only)
3 .2 Wiring Diagram
Figure 1 provides an example of the 4300/4400 toilet
wiring specifications.
For the 6500 toilet series, refer to the separately
I
packaged parts list for wiring information.
Material
Vitreous ceramic
Various plastics and metal
Various plastics and metal
Plated brass
EN
Publicité
Chapitres
Table des Matières
