FUTURA
17.2.
Pressed Wood BRIQUETTES AUTOMATIC operation
PROBLEM
POSSIBLE CAUSES
It switches from
Press and hold the P1 button
AUTOMATIC to
SLEEP function activated
MANUAL
Briquettes unloading
Presence of an
ALARM
Other alarms displayed on the
screen
UNLOADING
ALARM after
Insufficient ash layer
feeding the first
briquette
No power supply
Electrical cable not connected
The master switch of the stove
is off
Open hearth door
The DISPLAY
stays off
Open BRIQUETTES feed door
Overheating safety thermostat
in action
Faulty fuse
Electrical fault
No power supply
THE BRIQUETTE
Electrical fault
remains blocked
Mechanical fault
during ascent
During feeding
the INFEED
No power supply
DOOR in the
combustion
Electrical fault
chamber
Mechanical fault
remains partially
open
The comb lifting
During
has caused the
wood or briquettes were fed
ceramic GLASS
manually over the COMB
TO BREAK
8291003 - IT - EN - DE - FR
POSSIBLE SOLUTIONS
Press button P1 for more than 3 seconds
Disable the SLEEP delay feature
Briquettes feeder empty, feed briquettes and reset alarm by pressing and
See UNLOADING ALARM after feeding the first briquette
Call Technical Support
Open the door and with a poker increase the thickness of the embers in-
Reset power supply
Connect the electrical cable
Bring the master switch of the stove to position 1
Close the door
Close the door
Reset the safety thermostat
Replace the fuse.
In case of electrical fault call Technical Support
Check the doors are closed and wait for power to return
Check the fuse and call Technical Support
Check there are no jams
Call Technical assistance
Reset power supply
Call Technical Support
automatic
operation
Put the stove in manual mode, wait for it to switch off, and then call Techni-
holding the P1 button
troducing a briquette under the COMB on the ashes. Reset the alarm and
set the AUTOMATIC feature
cal Support
33