Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Using the irons, clean the burn pot air passages.
•
Remove ash from the lateral conveyors placed under the burn pot and near the ash drawer
15.10. BRIQUETTES FEEDER CLEANING
WARNING: This operation must be carried out without power supply !! Disconnect the power supply plug from the outlet.
Periodically carry out the automatic feeding system cleaning as any solid residues may cause jamming problems to the entire system.
On the bottom of the stove there is a removable tray for collecting briquette residues
15.11. AUTOMATIC SYSTEM MAINTENANCE
WARNING: This operation must be carried out without power supply !! Disconnect the power supply plug from the outlet.
Using the appliance continuously will cause the lubricant in the mechanical parts of the AUTOMATIC SYSTEM to progressively run out
over time, causing therefore poor sliding and more noise. For this reason each appliance is supplied with high temperature grease to make
it possible for the user to lubricate the system when necessary (excessive noise or sliding reduction).
Apply the supplied grease on the contact points and chains shown in
La NORDICA. IMPORTANT: After reassembling the left door, put the protective grommet on the protruding screw near the electric
socket, see
Picture 7 at page 65
15.12. OVERTEMPERATURE THERMOSTAT RESET
The product is provided with a safety thermostat that disconnects the electric power supply from the automatic system when it reaches
85°C. In AUTOMATIC mode it stops the supply of the fuel in the furnace favouring the appliance switch-off and slow cooling down. In
MANUAL mode nothing occurs, however on the next ignition in automatic mode, it will be necessary to reset the thermostat.
To reset the safety thermostat just open the combustion feed door located on the left side of the appliance, and press switch A shown
in
Picture 15 at page
68.
IMPORTANT: Before resetting the safety thermostat wait until the product has sufficiently cooled down. If this does not occur the
safety thermostat will intervene again, after a short time after ignition, by removing voltage.
WARNING: If after reset an anomaly is detected in the automatic briquettes feeding system, turn power off and call for service.
15.13. GASKETS
The gaskets guarantee the tightness of the stove and its consequent good functioning. These must be checked regularly: they must be
replaced immediately if they are worn or damaged. These operations must be carried out by an authorised technician.
16. DISPLAY TECHNICAL FEATURES
ENVIRONMENTAL SPECIFICATIONS
Ambient operating temperature
Storage temperature
Maximum relative humidity (without condensate)
ELECTRICAL SPECIFICATIONS
Power supply voltage
Maximum consumption
Maximum power absorption
Fuse protection
16.1.
DISPLAY SCREENS
DISPLAY
WOOD OPERATION
(MANUAL/AUTOMATIC)
AUTOMATIC INITIAL
CHECK UP
AUTOMATIC FEED
STAND-BY
AUTOMATIC
BRIQUETTE FEED
AUTOMATIC TROLLEY
ASCENT
30
B.
REASON
Stand-by for selecting MANUAL or AUTOMATIC operation
AUTOMATIC operation start
Stand-by for BRIQUETTE feed consent
Tank briquette withdrawal
Briquette transportation
(Picture 13 at page 67
Picture 14 at page
67. WARNING: Only use the grease supplied by
From 0°C to 60°C
From -10°C to +60°C
95%
230Vac 50/60 Hz
2.5 A – 250 Volt
Operator choice by pressing P1 key
AUTOMATIC operation mode selection
Check correct cast iron COMB positioning
FUTURA
(Picture 12 at page 67
B).
A).
MEANING
8291003 - IT - EN - DE - FR
Publicité
Table des Matières
