Unit Door; Ventilation Of The Kitchen Unit; Changing Over Door Hinges - V-ZUG Magnum 2 60i eco Notice D'installation

2.5 Unit door

- One door is required for the kitchen unit.
- The door must be minimum 16 mm and maximum 19 mm
thick.
- There must be a gap of minimum 3 mm width between the
door and the unit door located above it (if one exists).
- The width of the unit door depends on the style of the
kitchen and the gap size between the door panels of the
cabinet. Generally, there should remain a vertical gap of
3 mm between the unit doors.
- If other cabinets are present, the top edge of the unit door
should be on a level with the doors of the adjoining units.
- The unit door must be planar and mounted stress-free.
NOTICE
Risk of damage from over-heavy unit door!
If the unit door is too heavy, damage to the hinges and resulting
impairment of function cannot be excluded.
u Before mounting the unit door, make sure that the door does
not exceed the approved unit door weight.
Appliance model
Magnum 2 60i eco, Jumbo 60i,
Iglu 60i

2.6 Ventilation of the kitchen unit

- There must be an effective ventilation shaft of at least
200 cm per appliance at the air inlet
2
Fig. 3 (B) vent.
- The principle applies that the larger the ventilation shaft, the
more energy-saving the operation of the appliance.
- The depth of the ventilation shaft at the back of the cabinet
must be min. 40 mm.
* Depending on model and options
-
Maximum cabinet
door weight (kg)

2.7 Changing over door hinges

26
NOTICE
Risk of damage due to condensation and colliding doors!
If you are installing V-Zug Side-by-Side (SBS) appliances
next to each other:
u Install the appliances so that the doors open outwards.
Risk of injury if soft stop contracts!
u Carefully remove the soft stop mechanism.
Risk of injury if hinges fold!
u Leave hinges open.
Risk of injury due to the door dropping out!
If the fastening parts are not screwed into place firmly enough,
the door may drop out. This may lead to severe injuries. What is
more, the door may not close and therefore the appliance may
fail to cool properly.
u Screw the hinges and the ball journal of the soft stop mecha-
u Screw the holder of the soft stop mechanism firmly into
u Check all of the screws and retighten if necessary.
Note
The door hinges can only be changed over if there is sufficient
space towards the top to pull out the hinge mounting bracket
and to mount it again on the other side. This is generally not the
Fig. 3
case after installation in the recess.
u Change the hinges over before the appliance is installed in
Fig. 3 (A) and outlet
Putting into operation
The upper ventilation shaft can either be positioned directly
above the appliance with an optional ventilation grille
Fig. 4 (C) , close to the ceiling above the unit Fig. 4 (D) or as
an air outlet opening in a false ceiling
Switch the door hinges, if necessary.
CAUTION
CAUTION
WARNING
nism firmly into place, with 4 Nm.
place, with at least 3 Nm.
the recess.
There is a risk of injury during this stage! Please
observe the safety instructions!
The instructions apply to several models. Only carry
out this step if it is relevant for your appliance.
Fig. 4
Fig. 4 (E) .
19