Safety Instructions; Intended Use; User Profiles; Specific Fitting Instructions - Derungs Dmed HX LED 7 Instructions D'utilisation

EN
2

SAFETY INSTRUCTIONS

2.1

Intended use

med®
The D HX LED 7 treatment light is designed to
provide local illumination of the body of a patient for
diagnosis or examination. The light is not designed for
use in operating rooms. It is designed for continuous
operation. It must be possible to stop the examination or
diagnosis without danger to the patient if the light fails
during use.
2.2

User profiles

Medical staff
All persons with medical training who work in the field for
which they were trained.
Cleaning staff
All persons familiar with national and workplace-related
hygiene requirements.
Qualified electricians
All persons with training in electronics and electrical
engineering who are familiar with the relevant standards
and regulations.
Qualified professional
Persons qualified by training, knowledge, experience and
knowledge of the regulations to install and remove the
equipment.
2.3 Safety instructions
The lamp is to be operated by medical staff.

The instructions for use are an integral part of the

product; they are to be kept and made available for
all later users.
All work on the light (including repairs) must be

carried out by qualified electricians only. The light
must be installed
professional.
The light shall not be modified or manipulated. Use in

any other manner than according to the intended use
with the original parts may result in different
specifications and life-threatening dangers.
The light must not be used in an explosive

environment. The power supply of the light is a
potential ignition source.
The light must be used in dry and dust-free rooms

only.
The light must not be left on unattended.

Do not use a damaged light. Defective cables are

also a potential hazard. Do not position cables and a
defective handle near heat sources or sharp edges.
Eye damage. Never look directly at the light cone.

Replace damaged light source before using the light

again.
Never apply additional loads to the light head and

the arm system.
Do not cover the light with a cloth or similar while

operating.
The ventilation openings (if existing) must always be

free during operation!
The light must not be used close to external sources

of heat that exceed the ambient temperature limit.
The light must not be used outside its intended

ambient conditions.
10
exclusively by a qualified
The manufacturer cannot be held responsible for

damages due to uses different from the intended use
or to non-compliance with the safety instructions and
warnings.
Do not use with medical devices that may react

sensitively to a light spectrum within the visible range
(such as pulsating light and/or light with high
illumination intensity).
2.4

Specific fitting instructions

HX LED 7 P:

The light may be mounted only on walls that guarantee
sufficient hold. (wall mount)
2.5

Warning levels

DANGER
Warnings against hazards that may result in serious
injuries or death in case of non-observance.
WARNING
Warnings against hazards that may result in injuries in
case of non-observance.
CAUTION
Warnings against hazards that may result in material
damage in case of non-observance.
3

VARIANTS

3.1 HX LED 7 P
3.2

HX LED 7 F