Safety; Mounting Of The Ceiling/Wall Rail; Connection; Assembling Of The Luminaire - Derungs Dlite vanera LED Bed 50/20 Instructions D'installation Et De Fonctionnement

ENG
1

SAFETY

 Read all included instructions and informations.
 Please take notice of the alerts in the documents and
directly at the device.
 The device must be used in technically perfect condition,
and only by safety-conscious persons who are fully aware
of the risks.
 Keep all the instructions available at the device.
 The luminaire must only be operated in dry, dust-free
rooms.
 For luminaires in protection class I, it is essential for the
earthing conductor to be connected to the luminaire
housing.
 The manufacturer cannot be held responsible for an injury
or damage that is caused as a result of any use other than
the intended use or of any failure to comply with the safety
instructions and warnings. The manufacturer or a service
technician authorized by the manufacturer or a similarly
qualified person may only replace the light source of this
luminaire..
Intended use
The luminaire is authorized for use in medical areas (under
EN-60598-2-25). It is not intended for use in operating
theaters.
Explosion prevention
The use of the luminaire in explosive and hazardous
atmospheres could result in an explosion and in death or
serious injury.
 Do not use in explosive and hazardous atmospheres.
Danger of death from electric shock
Electric current in the luminaire result in death or serious
injury.
 Check: The mains voltage with the nominal voltage and the
frequency must match the data on the name plate.
 Before starting work disconnect the luminaire from mains.
 All maintenance and repairs must be done by qualified
personnel trained and authorised by the manufacturer.
2

MOUNTING OF THE CEILING/WALL RAIL

DANGER
Mounting by qualified personnel

Mounting must be done by qualified personnel only.
Lack of appropriate knowledge
threatening.
DANGER
Life-threatening danger from falling luminaire

The luminaire has to be mounted exclusively on a
massive ceiling/wall that guarantees a solid hold.

The supply voltage must correlate with the voltage noted
on the fixture's rating label.
6




3
Mortal danger from electric shock

CAUTION
Property damage caused by wrong supply voltage,
destruction or damage of the luminaire
 The mains voltage and the frequency must match
could be life-

4
CAUTION
Property damage of the luminaire in cause of
contamination of the sensitive inner life of the LED
luminaire.

Fix the ceiling/wall rail with the enclosed screw set on an
applicable ceiling/wall.
Distance „x": - vanera LED Bed 50/20 1049mm
- vanera LED 80:
- vanera LED 60:
- vanera LED Bath 40:
Wall version: Consider the position!
Screw both allen screws to a distance of 44 mm.

CONNECTION

DANGER
Make sure that the connecting cables are not under
voltage before you start wiring.
the data on the name plate.
Wiring according to page 15.

ASSEMBLING OF THE LUMINAIRE

If the prism cover is not attached to the luminaire,
handle with extreme caution and touch on the outer
sides only.
744mm
744mm
444mm