Product Dimensions; Venting Requirements - Haier HCH2100ACS Guide De L'utilisateur

FOR MOBILE HOME INSTALLATIONS
The installation of this range hood must conform to the Manufactured Home
Construction Safety Standards, Title 24 CFR, Part 328 (formerly the Federal
Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or when
such standard is not applicable, the standard for Manufactured Home Installation
1982 (Manufactured Home Sites, Communities and Setups) ANSI A225.1/NFPA
501A, or latest edition, or with local codes.

PRODUCT DIMENSIONS

34 "
(86.4 cm)

VENTING REQUIREMENTS

Makeup Air
Local building codes may require the use of makeup air systems when using
ventilation systems greater than specified CFM of air movement. The specified CFM
varies from locale to locale.
Consult your HVAC professional for specific requirements in your area.
General Venting
The vent hood is designed to vent through the roof or wall. To vent through a wall, a
90° elbow is needed.
•
Vent system must terminate to the outdoors except for non-vented
(recirculating) installations.
•
Do not terminate the vent system in an attic or other enclosed area.
•
If it is not possible to vent cooking fumes outside, the hood can be used for a
non-vented (recirculating) installation by attaching a deflector and a charcoal
filter. A Recirculatiing Kit is available for purchase.
•
Use metal vent only. Rigid metal vent is recommended. Plastic or metal foil vent
is not recommended.
•
The length of vent system and number of elbows should be kept to a minimum
to provide efficient performance.
NOTE: A 90° elbow must be installed immediately above the hood.
6
11¾ "
(29.8 cm)
18⅜ "
(46.7 cm)
2⅜ "
(6.0 cm)
19 "
(48.3 cm)
11 "
(27.9 cm)
24 " (61.0 cm) /
30 " (76.2 cm) /
35 ½ " (90.2 cm)