Naming Preset Stations And Program Sources - Sony STR-LSA1 Mode D'emploi

Naming Preset Stations and
Program Sources
You can enter a name of up to eight characters for preset
stations (excluding RDS stations) and up to 11 characters
for program sources (for up to 10 i.LINK components).
These names (for example, "LISSA CD") appear in the
receiver's display when a station or program source is
selected.
Note that no more than one name can be entered for each
preset station or program source.
This function is useful for distinguishing components of
the same kind. For example, two CD players can be
specified as "CD 1" and "CD 2", respectively.
1
Press JOG MENU repeatedly until a component
name appears in the display.
2
To index a preset station
Rotate the jog dial until "TUNER" appears in the
display.
The last received station is tuned in.
To index a program source
Rotate the jog dial to select the program source
(component) to be named, then go to step 4.
3
Tune to the preset station you want to create an
index name for.
If you aren't familiar with how to tune to preset
stations, see "Tuning to preset stations" on page 20.
4
Press JOG MENU repeatedly until "Setup Menu"
appears in the display.
5
Rotate the jog dial until "Name Input" appears in
the display, and press ENTER.
6
Create an index name by using the jog dial, <, and
>.
Rotate the jog dial to select a character, then press > to
move the cursor to the next position.
To select the character type
Press DISPLAY repeatedly until the character type you
want appears in the display.
To insert a space
Rotate the jog dial until a blank space appears in the
display (the space character is between "]" and "A").
To reenter a character
Press < or > repeatedly until the character to be
changed flashes, then rotate the jog dial to select a
character.
22 GB
If you attempt to name an i.LINK component
after you've already named 10 i.LINK
components
"List Full" appears in the display. To continue, erase
unwanted index name(s).
7
Press ENTER.
"MEMORY" lights up in the display for about one
second and the index name is entered.
To assign index names to other stations
Repeat steps 2 to 7.
Notes
• You can't create index names for RDS stations and the
component connected to the ANALOG IN connectors. "Not In
Use" appears in step 5 at this time.
• You can name only the preset station currently being tuned to
or the program source currently being selected. You can't name
stations which are not preset.
To erase an index name
1
Press JOG MENU repeatedly until "Setup Menu"
appears in the display.
2
Rotate the jog dial until "Name Erase" appears in
the display, and press ENTER.
3
Rotate the jog dial to select the index name you
want to erase.
4
Press ENTER.
Selected index name is erased.
Note
You can erase index names only for i.LINK components using
this procedure.