Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
Depress the "+" key on the flash unit for a positive
correction value when the flash shots are too dark,
and the "-" key for a negative correction value
when the flash shots are too bright. The correction
value can be adjusted from +10 to -10. The setting
becomes immediately effective and is automatical-
ly stored. The set correction value is taken over as
the new zero value ("0") for the next flash shot.
Maximum flash range indication is adapted to the
given correction value.
If the slave unit is not triggered repeat the
flash unit adaptation procedure and take
another test shot.
Tip:
Carefully read the next chapters of these Operat-
ing Instructions to be able to make full use of all
the capabilities of this flash unit.

6. Slave modes (SL)

Selection of the slave mode suitable for your ca-
mera depends on the properties and technology of
the camera-integrated flash. The important point is
to know whether the flash unit built into your came-
ra works with or without measuring preflashes.
Selection of the slave mode determines whether
the slave is triggered immediately after the first
flash pulse from the camera's flash unit, or whe-
ther one or more preflashes have to be suppressed
before the slave is triggered together with the ca-
mera's main flash.
Select one of the three different slave modes by
repeated combined depression of the "MODE"
and
pre-select keys. The selected slave mode
flashes on the LC display of the flash unit.
Establishing the slave mode suitable for your
camera
It is not necessary to establish the suitable
slave mode if you know whether or not your
camera operates with preflash measuring
technology!
Often it is rather difficult to establish whether or not
a digital camera operates with preflash measuring
technology. Proceed in the following manner to se-
lect the slave mode that is suitable for your camera:
k
93

Publicité

Table des Matières
loading

Table des Matières