EMAK GSH 400 Manuel D'utilisation Et D'entretien page 35

persists, immediately stop the work and
contact an Authorized Service Center to solve
the problem.
WARNING - Weather conditions and
altitude may affect carburation. Do not
allow anyone to stay close to the chainsaw
while working or while adjusting the
carburetor.
MUFFLER
WARNING – This muffler incorporates
a catalytic converter, needed in order
to ensure the engine complies with current
emissions standards. Never attempt to modify or
remove the catalytic converter: in doing so, you
will be breaking the law.
WARNING – Mufflers with catalytic
converters become very hot during
operation, and retain heat for a long time
after the engine has been stopped. This is the
case even with the engine idling. Contact can
burn the skin. Always remember the potential
fire risk!
CAUTION – If the muffler is damaged, it
must be replaced. If the muffler frequently
becomes blocked, this could be an indication
that the efficiency of the catalytic converter is
limited.
WARNING – Do not use the chain saw if
the muffler is damaged or missing, or
has been altered in any way. Operating the
machine with an improperly maintained
muffler will increase the risk of fire and
hearing loss.
EXTRA MAINTANANCE ADVISABLE
It is advisable to inspect the machine by a
specialized technician at an authorized service
network at the end of season, if used intensively,
and every two years if with normal use.
WARNING! – Any maintenance operations
not specifically dealt with in this manual
must be carried out by an authorized service
center. To ensure that your chainsaw continues
to function correctly, use only ORIGINAL
REPLACEMENT PARTS.
Any unauthorized changes and/or
use of non-original replacement parts
may result in serious injury or death to the
operator or third parties.
TRANSPORTION
Carry the chainsaw with the engine stopped,
guide bar to the rear and chain cover on (Fig. 31).
WARNING - When transpor ting the
machine on a vehicle, ensure that it is
firmly and securely fastened using straps or
belts. The machine must be transported in the
horizontal position, also ensuring compliance
with applicable transport regulations for such
machines.
I
GB
F
D
E
NL
GB
GR
TR
CZ
SK
RUS
UK
PL
H
LV
EST
LT
RO
35