Preparation - Vetus ILTCONW Instructions D'installation Et Mode D'emploi

Fitting in sailing boats
When fitting remember that the filler hose
must always be positioned on the same side of
the boat as the tank.
6

Preparation

The tank must have a threaded connection.
ATANK tanks (42 to 390 liters)
An inspection cover ILT120 must be fitted to
these tanks.
Mounting inspection lid
• Mount the inspection lid ILT120, this is not
included in the supply. For installation in­
structions consult the manual supplied with
the inspection lid.
• Do not install the nut with the blind plate.
The blind plate is not used.
APT100 tanks
These tanks have already been fitted with a
collar with screw thread, remove the nut and
remove the blind plate and the gasket.
vetus® Connection kit for waste water tanks
This prevents too high a pressure from possibly
occurring in the tank when sailing heeled.
ENGLISH
ATANK...
APT100
17
110141.01