Photoelectric Sensor; Operation; Inserting/Changing The Battery - VOLTCRAFT SLX-300 Notice D'emploi

b) Photoelectric sensor
8
9
8 Sensor

8. Operation

a) Inserting/changing the battery
• Insert the battery before using the device for the first time. Follow the steps below to insert the battery:
Replace the battery when the battery status symbol (L) indicates a low battery (
• To replace the battery, remove the old battery from the battery connector and follow the steps above.
20
10
9 Compass
• Open the battery compartment cover (6) on the back
of the measuring device by sliding it downwards.
• Fold the battery compartment cover upwards.
• Connect the battery connector to the battery. Always
observe the correct polarity (positive/+ and nega-
tive/-).
• Insert the 9 V block battery provided into the battery
compartment. Stow the battery connector cables in
the battery compartment.
• Fold the battery compartment cover downwards and
slide it back into place.
10 Sensor cover
).