Cleaning And Care - Sibir GS 110 A Manuel D'utilisation

en
Use a sponge or a soft cloth to remove thawing
water if necessary (Fig. 5).
Keep the door open during defrosting.
For quicker defrosting, place containers with
warm water inside the appliance.
Never use electrical devices, defrosting sprays
or pointed or sharp-edged objects such as
knives or forks to remove the ice.
After the defrosting is done, clean the inside
(see the section 'Cleaning and care').
Reconnect the appliance to the mains. Place
the frozen food into the drawers and slide the
drawers into the freezer.

Cleaning and care

Interior and Exterior Surfaces
Attention
Always unplug the power cable or switch
off the circuit breaker before cleaning.
Clean the exterior using lukewarm water and
a mild detergent.
Never use detergents, abrasive or acidic
agents.
Wipe the inside compartment dry.
Be careful to prevent water from getting into
contact with the electrical connections of the
temperature control or the interior light.
If the appliance is not going to be used for a
long period of time, unplug the power cable
and remove all food. Clean the appliance and
keep the door open.
To preserve the appearance of your appliance,
you can polish the exterior and the door
accessories with a silicone wax.
Clean the condenser at the back of the
appliance once a year using a brush or a
vacuum cleaner. Dust build-up leads to
increased energy consumption.
Inspect the door gasket at regular intervals.
Clean with water only, and wipe totally dry.
Cleaning of the accessories
Drawers:
To clean a drawer, pull it out as far as possible,
tilt it upwards and then pull it out completely.
6
en