Aqua Medic S Gen II Mode D'emploi page 5

The Aqua Medic multi reactors S, M and L of the second generation are plug-and-play reactors for use
within the aquarium or filter sump, and can be used for fresh and saltwater aquaria for up to 350 l/92 gal, 500
l/132 gal or 800 l/211 gal respectively.
1. Technical Information
multi reactor
Dimensions (l x w x h)
Gross volume
Max. Filling quantity
(without sponge)
Voltage
Current consumption
Pump power
For aquaria
For glass thickness of
2. Set-Up and Operation
Pict. 1: 1. Holding unit
ring) 6. Outlets
If the sponge (3) is dirty and needs to be cleaned, shut-off the pump, open the filter body and clean the sponge
with water.
Our multi reactors S, M and L Gen II are designed to operate either directly inside the aquarium or inside
the filter sump. With the supplied holding unit, the multi reactor can be mounted horizontally on the aquarium
glass. The pump needs to be fully submerged to prevent air suction. The entire body may only be submerged
maximum up to the outlets (6) on top of the unit. The immersion depth of the unit can be adjusted by opening
the clamp screw. If the reactor cannot be put deeply enough into the water due to a low water level, splashing
Operation Manual ENG
S
~ 60 x 50 x 335 mm
~ 270 ml
~ 150 ml
220 - 240 V / 50 - 60 Hz
12 V / ~ 4 watts
~ 200 l/h
up to 350 l
12 mm
2. Turning knob (flow regulator)
M
~ 80 x 60 x 390 mm
~ 540 ml
~ 380 ml
220 - 240 V / 50 - 60 Hz
12 V / ~ 8 watts
~ 350 l/h
up to 500 l
12 mm
3. Sponge 4. O-rings (S + M: 2 O-rings, L: 1 O-
L
~ 100 x 100 x 465 mm
~ 1.200 ml
~ 800 ml
220 - 240 V / 50 - 60 Hz
12 V / ~ 14 watts
~ 450 l/h
up to 800 l
12 mm
5