Auto-Entry" Function (Automatic Code Detection); Deactivating The Sound Signals - Renkforce 754389 Notice D'emploi

g) „Auto-Entry" Functions (Automatic Code Detection)
2  #
+ + = Activate „Auto-Entry" function
After user code input, (or input of a code for the access lock), confirmation with the
#
button „ " is no longer required.
In the operating mode „Multi-User", however, the code length of master and
user code must be the same.
It is not permissible, e.g., to use a 4-digit master code and 6-digit user code.
The „Auto-Entry" function is activated in the mode „Single-User" in the basic
setting but can be switched off on request; see below.
2 0 #
+ + = Deactivate „Auto-Entry" function
After user code input, confirmation with the button „
This setting is required if you want to use differently long codes for master code
and user code or codes for access lock in „Multi-User" mode.
h) Deactivation of the Sound Signals
3  #
+ + = Activate sound signals
The sound signals of the code lock are activated, e.g. at button confirmation.
3 0 #
+ + = Deactivate sound signals
The sound signals are deactivated. This setting is sensible, e.g. in calm office environ-
ments etc.
If the programming mode is started with the master code, the sound signals
are activated for the duration of the programming (to provide feedback for the
button confirmation).
46
#
" is required.