Signal Sounds And Led Displays - Renkforce 754389 Notice D'emploi

9. Signal Sounds and LED Displays

The three LEDs on the front (see figure in chapter 7, items 2, 3 and 4) have the following
functions:
Red LED:
Lights up if the access lock has been activated. In this operating mode, the user code
cannot activate the relay in the code lock.
Only when the code for the access lock is entered again and the LED goes out is the
code lock ready for operation again.
Yellow LED:
This serves as confirmation or function LED together with the installed Piezo buzzer.
Status
Programming mode
Operation of button
Entered code ok
Entered code not ok
DAP jumper on „ON"
Standby
Relay activated
The yellow LED flashes 5x (additionally 5x sound signal), even if the buttons
are pushed with more than 10 seconds in between or when the entire input of
the code takes more than 30 seconds.
Green LED:
The relay has been activated by input of the correct code. The activation duration is
according to the programming performed by you (1....999 seconds or toggle operation).
38
Piezo buzzer
-
1x beep
2x beep
5x beep
Continuous beeps
-
1x long sound (1 s)
LED
Permanently lit
1x flash
2x flash
5x flash
Continuous flashing
1x flash every 2 s
-