Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Adjusting the video
07
Select and set Display Setting Video Adjust.
1
Use / to select, then press ENTER.
2
Select and set Custom.
Use / to select, then press ENTER.
3
Select the item and change the setting.
Use / to select the item, then use / to change the
setting. Once the setting is completed, press
RETURN to close the settings screen.
Item
Prog.Motion
Pure Cinema
Brightness
Contrast
Hue
Saturation
Detail
YNR
CNR
MNR
BNR
Note
• The Video Adjust settings do not affect Blu-ray 3D
pictures or the pictures of the HDMI OUT (SUB)
terminals.
42
En
Description
Adjust according to the type of image
(moving or still image). This is effective
mainly when outputting video materials
as progressive images.
This setting optimizes the operation of
the progressive scanning circuit for
playing film materials.
Select this to adjust the TV screen's
brightness.
Select this to adjust the TV screen's
contrast.
Adjusts the balance between green and
red.
Select this to adjust the TV screen's
saturation.
Adjusts the picture's contours.
Reduces noise in the luminance (Y)
signal.
Reduces noise in the chroma (C) signal.
Reduces the mosquito noise (distortion
along the contours of the picture
generated upon MPEG compression).
Reduces the block noise (block-shaped
distortion generated upon MPEG
compression).
Setting the IP address
Select and set Network IP setting Next
1
Screen.
Use / to select, then press ENTER.
2
Set IP address.
Use /// to set the IP address of the player or DNS
server, then press ENTER.
• Auto Set IP Address
On – The player's IP address is obtained
automatically. Select this when using a broadband
router or broadband modem that has a DHCP
(Dynamic Host Configuration Protocol) server
function. This player's IP address will automatically
be allocated from the DHCP server.
Off – The player's IP address must be set manually.
Use the number buttons (0 to 9) to input the IP
address, subnet mask and default gateway.
Note
• For information on the DHCP server function, refer to
the operating instructions for the network device.
• You may need to contact your Internet service
provider or network administrator when inputting the
IP address manually.
Setting the proxy server
Only set the proxy server if so instructed by your Internet
service provider.
Select and set Network Proxy Server Next
1
Screen.
Use / to select, then press ENTER.
2
Select and set Use or Not use at Proxy Server.
Use / to change, then press .
• Use – Select this when using a proxy server.
• Not use – Select this when not using a proxy server.
If you have selected Use, proceed to step 3.
3
Select and set Server Select Method.
Use / to change, then press .
• IP Address – Input the IP address.
• Server Name – Input the server name.
4
Input IP Address or Server Name.
Use the number buttons (0 to 9) to input the number if you
select IP address in step 3. Use / to move the cursor.
When Server Name is selected in step 3, use the number
buttons (0 to 9) to launch the software keyboard. Now use
/// to select characters and items, then press
ENTER to input.
5
Input Port Number.
Press , then use the number buttons (0 to 9) to input
the number.
6
Press ENTER to set.
Publicité
Chapitres
Table des Matières
