Table des Matières
Publicité
Failure
(4) The Multicontroller works at
very low power only.
(5) The LED on the Multicontroller
are lit correctly, but the pumps
connected operate at 100 % all
the time.
(6) When the chance mode is
started, the Turbelle
®
loud.
Cause
The power of the driver has not
been set to 100 %.
The connecting cable between the
Multicontroller and the driver is
defective.
Elder models of Turbelle
pumps are
require an internal O ring seal
7400.71 (as from 05/2004) in the
pump drive.
Remedy
Turn the „POWER" adjusting
screw on the driver clockwise up
to stop to 100 %.
Replace
7092.30.
®
pumps
Fit drive 7200.60 in Turbelle
electronic or drive 6100.60 in
®
Turbelle
connecting
cable
stream.
®
69
Publicité
Table des Matières
