Babboe City Mountain Manuel D'utilisation page 30

5.13 Trip meter
This displays the total riding distance (in kilometers or miles)
since it was last reset.
When you turn off the power, the data up to that point will
remain in the display. To reset the trip meter and begin
counting a new total, press the function select switch for 2
seconds or longer when the trip meter is displayed.
5.14 Odometer
Deze optie toont de totaal afgelegde afstand (in kilometers
of mijlen) met ingeschakeld display. U kunt de waarde van de
totaal afgelegde afstand niet op nul zetten.
5.15 Remaining assist distance
This displays an estimate of the distance (in kilometers or
miles) that can be traveled with assist on the residual battery
capacity of the battery installed. If you switch the assist mode
when the remaining assist distance is displayed, the estimate
of the distance that can be traveled with assist changes.
The remaining assist distance estimate cannot be reset.
TIP
• The remaining assist distance changes depending on the
riding situation (hills, headwind, etc.) and as the battery
runs out/low.
5.16 Battery capacity (%)
This displays the power remaining in the battery.
The residual battery capacity display cannot be reset.
5.17 Cadans
Deze optie toont uw pedaalsnelheid in omwentelingen per minuut.
U kunt de waarde van de pedaalsnelheid niet op nul zetten.
TIP
If you pedal backwards, '0.0' is displayed.
58
5.18 Light on/off
Each time you press the light switch, the light switches
between "On" and "Off". When the light is activated/turned
on, the back light of the display also lights up.
NOTICE
If the battery becomes exhausted while cycling and no longer
provides power assist, the light will remain on for about 2 more
hours. Remember this, when you may be cycling in the dark.
5.19 Pushing assist
When you are on or off the bicycle and start moving it, you
can use pushing assist without pedaling the bicycle.
To use pushing assist, press and hold the pushing assist switch.
Pushing assist will stop in the following situations:
• When you release the pushing assist switch.
• If you press another switch at the same time.
• When you start to pedal.
• If your bicycle speed exceeds 6 km/h.
• If you select Off mode.
• If the wheels are not turning (when braking or coming
into contact with an obstacle, etc.).
5.20 Clock and km/mile settings
Use the following steps to set the time and km/mile settings:
1. Make sure that the display is mounted on the display
holder, and that the display unit is turned off.
2. Press the power switch while holding the function
select switch.
3. When the "hour" on the clock begins to flash, release
the switches.
4. Use the assist mode switches (up & down) to set the "hour".
5. Press the function select switch, and the "minutes" on the
clock will begin to flash.
6. Use the assist mode switches (up & down) to set the
"minute".
7. Press the function select switch, and the distance (km or mile)
and speed (km/h or MPH) will begin to flash.
8. Use the assist mode switches (up & down) to switch
between 'km & km/h' and 'mile & MPH'.
9. Press the power switch. The settings are saved and this
function is exited.
59