Stihl SE 122 Notice D'emploi page 23

Route the power cord and extension
cord properly:
Observe the minimum cross-section
–
of the individual cords – see
"Connecting the machine to the
power supply"
Route and mark the power cord so
–
that it cannot become damaged and
no one is endangered – danger of
stumbling!
Use of unsuitable extension cords
–
can be dangerous. Use only
extension cords that are approved
for outdoor use and are
correspondingly marked and have a
sufficient cross-section
The connector and coupling of the
–
extension cord must be waterproof
or routed in such a way that they
cannot come into contact with water
– the connector and coupling of the
extension cord must not lie in water
don't let the cord rub against edges
–
or pointed or sharp objects
don't squeeze the cord under doors
–
or windows
if cords become snarled – unplug
–
the power plug and unsnarl the cord
always unroll the power cord from
–
the cable reel completely to avoid
risk of fire due to overheating
During operation
If the connecting cord is
damaged, immediately
disconnect the power
plug from the wall outlet –
risk of electric shock!
SE 122, SE 122 E
Ensure that the connecting cord is not
damaged by being driven over,
squashed or pulled, etc.
Never unplug the power plug by pulling
on the connecting cord: always grip the
plug itself.
Only touch the power plug, connecting
cord and extension cord and electrical
plug connections with dry hands.
Never spray electrical devices with
water – Danger of short-circuiting!
In the event of imminent danger or in an
emergency – move switch to 0 .
Never let the machine run unattended.
Do not leave the machine outdoors in
the rain.
The machine may only be operated in an
upright position. Do not cover the
machine and ensure adequate motor
ventilation.
Ensure that the filter element is always
undamaged.
If foam develops or liquid escapes, stop
work immediately, unplug the power
plug, and empty the container.
If the machine is subjected to a strain for
which it was not designed (e. g., heavy
impact or a fall), always check that it is in
good condition before continuing work -
refer also to the chapter "Before starting
work". Also make certain that the safety
mechanisms are working properly.
Never continue using a machine that is
not in perfect working order. In case of
doubt, have the unit checked by your
servicing dealer.
Before leaving the machine unattended:
Switch off the machine – unplug the
power cord.
After finishing work
Unplug the power plug from the socket
Never unplug the power plug by pulling
on the connecting cord: always grip the
plug itself.
Always clean dust and dirt off the
machine – do not use any grease
solvents for this purpose.
Maintenance and repairs
WARNING
Before starting any work
on the machine: Always
disconnect the machine
from the mains power
supply.
Use only high-quality spare parts.
–
Otherwise, there may be a risk of
accidents and damage to the unit. If
you have any questions in this
respect, consult a servicing dealer.
To avoid risks, work on the machine
–
(e. g. replacing a damaged
connecting cord) may only be
carried out by authorized dealers or
qualified electricians.
Clean plastic parts with a cloth. Harsh
detergents may damage the plastic.
Clean ventilation slots in motor housing
as needed.
The machine must be serviced regularly.
Do not attempt any maintenance or
repair work not described in the
Instruction Manual. All other work should
be carried out by a servicing dealer.
English
21