Timex EASY TRAINER Mode D'emploi page 55

Maintenance
The chest sensor and its elastic strap should be rinsed in fresh water to avoid the
buildup of materials that can interfere with the measurement of your Heart Rate.
The watch monitor does not need to be rinsed.
1. Do not clean the chest sensor with abrasive or corrosive materials. Abrasive
cleaning agents may scratch the plastic parts and corrode the electronic
circuit.
2. Do not subject the sensor to excessive force, shock, dust, temperature, or
humidity. Such treatment may result in malfunction, a shorter electronic life
span, damaged batteries, or distorted parts.
3. Do not tamper with the sensor's internal components. Doing so will terminate
the sensor's warranty and may cause damage. The sensor contains no
user-serviceable parts.
INDIGLO night-light
®
Press INDIGLO button to activate light. Electroluminescent technology illumi-
®
nates the watch display at night and in low light conditions.
Battery Information
This product uses a CR2032 lithium battery for the sensor and a CR2025 lithium
battery for the watch.
When the battery of the watch is running low, the display will dim.
If the Heart Rate readings become erratic or stop, your chest sensor battery may
need replacing. You can do this by yourself very easily without any special tools.
6
TO CHANGE THE CHEST SENSOR BATTERY:
TOP VIEW
1. Open the sensor battery lid with a coin by turning counterclockwise.
2. Insert one CR2032, 3V lithium battery with writing facing you.
NOTE: Take care not to touch the two contacts, otherwise the battery can
discharge.
3. Replace lid.
If you are unsure about the procedure consult your dealer.
A quick test of the unit should be performed after changing the battery:
1. Move away from any possible sources of electrical or radio interference.
2. Liberally moisten the sensor pads and put the sensor on your chest, securely
against your skin.
3. In Time of Day mode press ON/OFF
4. The display will switch from the time display, "---" will appear and the {g}
will fill and flash to indicate that the wrist monitor is receiving your Heart Rate.
This indicates that the battery was installed correctly.
SIDE VIEW
Battery
Battery contact plate
7