Tool Specifications; Machine Elements; Intended Use - Würth mater EWS 24-180 Mode D'emploi

EWS 24.book Seite 16 Dienstag, 6. Oktober 2009 10:09 10
Angle Grinder
Article number
Rated power input
Output power
No-load speed
Grinding disc dia., max.
Max. permitted thickness of the cut-off or grinding
disc
Max. permitted thickness of the application tool in
the clamping range when using clamping nut 15
Max. permitted thickness of the application tool in
the clamping range when using clamping nut 14
Grinder spindle length
Grinder spindle thread
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltages and models for specific countries, these values
can vary. Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.

Machine Elements

1 Spindle lock button
2 Locking lever for protection guard
3 Grinder spindle
4 On/Off switch
5 Safety switch against starting/lock-on*
6 Release button for turning handle
7 Auxiliary handle
8 Protection guard for grinding/roughing
9 Protection guard for cutting
10 Hand guard
11 Wire brush
12 Mounting flange
13 Grinding/cutting disc**
14 Quick-clamping nut*
15 Clamping nut*
16 Two-pin spanner for clamping nut*
17 Electronics malfunction indicator (LED)
*Depending on version
**Not all of the accessories illustrated or described are
included as standard delivery.

Intended Use

The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting stone, a cutting guide is required.
16

Tool Specifications

EWS 24-180
EWS 24-180-S
0702 445 X
[W] 2400
[W] 1600
[min -1 ] 8500
[mm] 180
[mm] 8
[mm] 14
[mm] 10
[mm] 25
[mm] 14
[kg] 5,7
The protection guard is not approved for all grinding
accessories.
For damage caused by usage other then intended,
the user is responsible.
Mounting the Protective Devices
Disconnect the mains plug from electric supply.
Protective Guard (see figure
For work with cut-off discs, a special protection
guard for cutting 9 must be mounted.
8
Press locking lever 2 and mount protection guard 8
on the spindle collar as shown
Firmly press the protection guard 8 on the machine
and turn the protection guard 8, so that it engages
in the required position. Let go of the locking lever
2.
Adapt the position of the protection guard 8 to how
the machine is being held.
EWS 24-230
EWS 24-230-S
EWS 24-230-T
0702 446 X
2400
1600
6600
230
8
14
10
25
14
5,8
/ II / II
)
A
2