■
Do not use the device if highly fl ammable gases are present in the air.
■
Never submerge the motor unit in water or other liquids! Make sure that the motor
unit, the cord or the plug can not fall in water or get wet.
■
If the motor unit falls in water, immediately disconnect the power supply.
■
Never touch the motor unit, the cord or the plug with wet hands.
■
Only connect the device to a socket, which has been properly installed and complies
with the device's technical data (see chapter "Technical data").
■
Lay the cord such that it is not crushed or creased and such that it does not come
into contact with hot surfaces.
■
Pull the mains plug out of the socket if you do not use the device, if a defect occurs
while in use or before a storm.
■
If you want to remove the mains plug from the socket, never pull on the cable, but
always on the plug.
Avoiding damage to materials, property and the device
■
Check the device for damages prior to each use. The device must not be used if the
motor unit, the accessories, the mains cord or plug exhibit visible damages. Do not
attempt to repair the device or replace the cable and/or plug yourself. In the event of
damage, promptly contact the customer service department.
■
Each time before using the device, check whether the device is clean and dry and
whether it has been correctly assembled and closed.
■
The device should only be used when it is fully assembled, undamaged, and opera-
tional!
■
Always place the device on a dry, even, and fi rm base.
■
Do not use any additional accessories. Only use the enclosed accessories from the
manufacturer.
■
Do not let the motor run if the device is empty.
■
Always keep hold of the motor unit with one hand while preparing food.
■
Do not use the device for longer than 1 minute without interruption. A cooling-down
period of 2 minutes must then be maintained.
■
Do not overfi ll the mixing beakers or the mixing container. Only fi ll the large mixing
beaker and the mixing container up to the MAX mark. Only fi ll the small beaker up to
three quarters with food.
■
The device must not be transported when switched on. Always pull the mains plug
out of the socket and allow the motor to come to a full stop prior to moving the device.
■
Do not allow the device to fall and do not subject it to strong percussions.
■
Do not subject the device to extreme temperatures, severe changes in temperature,
direct sunlight or moisture.
Hygienic notes
■
There may be some production residue stuck to the device. To avoid health risks,
clean it thoroughly before fi rst use (see chapter "Cleaning and Storage").
■
Clean the accessories thoroughly with warm water and a small amount of mild deter-
gent immediately after each use to prevent the build-up of germs. Do not allow any
residual food to dry onto it.
13
EN