Possible Faults; Technical Data - ATIKA BWS 400-2 Notice Originale

Possible faults

Before each fault elimination:

Switch off device
 Wait until the saw comes to a stop
 Pull out power plug

After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after switching on
Jigging does not work
Machine stops while cutting
Burned spots at the cut areas
Saw vibrates
Recuperating mechanism of the jigging device
does not work
Decelaration too slow (time to dead stop >10
sec.)

Technical data

Type
Year of construction
Motor rating P
1
Mains voltage
Mains frequency
No-load speed n
0
Protection class
Mains fuse
Saw blade (carbide tipped saw blade)
Saw blade location hole 
Number of teeth
Thickness of splitting wedge
Cut width
max. cutting capacity
Wood length, max.
Wood length, min.
Dimensions (length x breadth x height)
Weight (incl. accessories)
18
Possible cause
 Power failure
 Extension cable defect
 Motor or switch defect
 Safety flap not pressed down properly.
 Saw blade blunt
 Feed is too great
 Saw blade blunt
 Saw blade is warped
 Saw blade not properly mounted
 Recuperating spring broken or worn out
 Recuperating bolt popped out from its bracket
 Motor brake defective
Remedy
 Check the fuse.
 Check cable, no longer use defect cable
 Have motor or switch checked by an approved
electrician or replaced by original spare parts
 Press down the safety flap properly.
 Replace saw blade or have it sharpend
 Allow motor to cool and proceed working with
less pressure
 Replace saw blade or have it sharpend
 Replace saw blade or have it sharpend
 Mount saw blade properly
 Replace the recuperating spring
 Insert the recuperating bolt in its bracket and
secure it with a cotter pin
 Have motor or switch checked by an approved
electrician or replaced by original spare parts
2.2 KW (S2 15 Min – temporary duty 15 minutes)
approx.  min. 30 mm to max. 140 mm
1002 x 737 x 1046 mm
Technical modifications reserved!
BWS 400-2
see last page
230 V~
50 Hz
2800 min
–1
IP 54
16 A slow
 405 mm
30 mm
32
2.2 mm
3.0 mm
1000 mm
300 mm
38.3 kg